TOHATSU BFT75A - Ecm Terminal Arrangement

5-11
dummyheaddummyhead
FUEL SYSTEM
ECM TERMINAL ARRANGEMENT
ECM CONNECTOR A (GRAY)
ECM side connector (viewed from the terminal side)
Terminal No. Terminal mark Name Content/Signal
1– – –
2 ACGLP Alternator indicator light Alternator indicator light output
3 WARNL MIL MIL output
4 TACHO Tachometer Tachometer pulse output
5– – –
6 TRMA Trim angle sensor Trim angle sensor input
7 TE EBT sensor EBT sensor input
8 THL TP sensor TP sensor input
9 PB MAP sensor MAP sensor input
10 POIL EOP sensor EOP sensor input
11 K-LINE Communication signal Serial communication signal input/output
12 IGN2 No.2 ignition coil No.2 ignition coil signal output
13 FLR1 Fuel pump relay 1 Fuel pump relay 1 driver
14 FLR2 Fuel pump relay 2 Fuel pump relay 2 driver
15 IGN1 No.1 ignition coil No.1 ignition coil signal output
16 – – –
17 PG3 Power ground 3 Power ground 3
18 O2HT HO2S heater HO2S heater driver
19 BUZZ Warning buzzer Warning buzzer driver
20 CRK CKP sensor (+) CKP sensor (+) input
21 – – –
22 TOH1 ECT sensor 2 ECT sensor 2 input
23 TA IAT sensor IAT sensor input
24 TDC CMP sensor CMP sensor input
25 – – –
26 TOH2 ECT sensor 3 ECT sensor 3 input
27 O2 HO2S HO2S input
28 – – –
29 – – –
30 IGN3 No.3 ignition coil No.3 ignition coil signal output
31 OPL Oil indicator light Oil indicator light driver
32 OHL Overheat indicator light Overheat indicator light driver
33 IGN4 No.4 ignition coil No.4 ignition coil signal output
34 FUP Fuel consumption meter Fuel consumption volume signal output
35 PG4 Power ground 4 Power ground 4
36 – – –