TOHATSU BFT75A - Ect Sensor 2 Removal;Installation; Ect Sensor 3 Removal;Installation

5-85
dummyheaddummyhead
FUEL SYSTEM
ECT SENSOR 2 REMOVAL/
INSTALLATION
Remove engine cover.
Disconnect the ECT sensor 2 (2P) connector [1] from
ECT sensor 2 [2].
Remove ECT sensor 2.
Apply engine oil to a new O-ring [3] and install on ECT
sensor 2.
Apply liquid sealant (Threebond
®
1201, 1215 or
equivalent) to the threads and seating surface of ECT
sensor 2.
Install ECT sensor 2 and tighten to the specified torque.
Connect the ECT sensor 2 (2P) connector.
Install the engine cover.
ECT SENSOR 3 REMOVAL/
INSTALLATION
Remove engine cover.
Disconnect the ECT sensor 3 (2P) connector [1] from
ECT sensor 3 [2].
Remove ECT sensor 3.
Apply engine oil to a new O-ring [3] and install on ECT
sensor 3.
Apply liquid sealant (Threebond
®
1201, 1215 or
equivalent) to the threads and seating surface of ECT
sensor 3.
Install ECT sensor 3 and tighten to the specified torque.
Connect the ECT sensor 3 (2P) connector.
Install the engine cover.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
[1]
[3]
[2]
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
[1]
[3]
[2]