TOHATSU BFT75A - Fuel Pump (High Pressure Side);Vapor Separator Disassembly;Assembly

5-91
dummyheaddummyhead
FUEL SYSTEM
FUEL PUMP (HIGH PRESSURE SIDE)/VAPOR SEPARATOR
DISASSEMBLY/ASSEMBLY
COMPONENTS LOCATION
Remove the fuel pump (high pressure side) and vapor separator (page 5-76).
PUMP COVER
PUMP HARNESS
PRESSURE
REGULATOR
CORD CLAMP
3.4 N·m (0.35 kgf·m, 2.5 lbf·ft)
PRESSURE REGULATOR
CONTROL TUBE
11.8 N·m (1.2 kgf·m, 9 lbf·ft)
BOLT (6 x 14 mm) (2)
PRESSURE REGULATOR
CONTROL TUBE
FUEL PIPE JOINT
O-RING (2)
BOLT (6 x 25 mm)
11.8 N·m (1.2 kgf·m, 9 lbf·ft)
SERVICE CHECK BOLT
O-RING
O-RING
FUEL STRAINER
(HIGH PRESSURE SIDE)
SPRING
STRAINER
COVER
SEALING WASHER
O-RING
FUEL PUMP
(HIGH PRESSURE SIDE)
INSULATOR
INSULATOR
HOLDER
VAPOR SEPARATOR BODY
BRACKET
11.8 N·m (1.2 kgf·m, 9 lbf·ft)
BOLT (6 x 25 mm) (3)
PUMP CASE
O-RING
COLLAR (2)
GROMMET (2)
VINYL TUBE
O-RING
1.5 N·m (0.15 kgf·m, 1.1 lbf·ft)
DRAIN SCREW
3.4 N·m (0.35 kgf·m, 2.5 lbf·ft)
SCREW-WASHER (3)
2.1 N·m (0.21 kgf·m, 1.5 lbf·ft)
SCREW
O-RING
GROMMET
FUEL TUBE CLAMP B
SCREW-WASHER (5 mm) (3)
RING