TOHATSU BFT75A - Air Vent Strainer;Check Valve Removal;Installation

5-86
dummyheaddummyhead
FUEL SYSTEM
AIR VENT STRAINER/CHECK VALVE REMOVAL/INSTALLATION
Remove the intake manifold (page 5-69).
• Check each tube for deterioration or cracks and replace the tubes if necessary.
• After assembly, check that the tube clamps are set securely (page 2-43).
CHECK VALVE
ASSEMBLY:
Install with the
arrow mark
toward check
valve tube A.
CHECK VALVE
TUBE B
CHECK VALVE
TUBE A
AIR VENT
TUBE A
FUEL TUBE CLAMP A (2)
FUEL TUBE CLAMP B (7)
TUBE CLAMP
TUBE CLIP (B12) (2)
(LRTA/XRTA/LRTC/
XRTC type only)
FUEL HOSE
JOINT
FUEL TUBE
C
FUEL TUBE
CLAMP
BRACKET
BOLT
(6 x 14 mm) (2)
AIR VENT
TUBE C
AIR VENT
TUBE B
FUEL PUMP
(LOW PRESSURE
SIDE)
BOLT
(6 x 22 mm) (2)
TUBE CLAMP
(7.5 - 11.5) (2)
T-JOINT
FUEL TUBE E
BOLT
(6 x 14 mm) (2)
HARNESS CLIP
BRACKET B
FUEL STRAINER
(LOW PRESSURE
SIDE)
STRAINER
SUSPENSION
FUEL TUBE D
O-RING
AIR VENT
STRAINER
HOSE CLIP
TUBE CLIP (B12)
(5)
TUBE CLAMP (D12) (2)
(Except LRTA/XRTA/
LRTC/XRTC type)
FUEL
TUBE C