TOHATSU BFT75A - Standard Torque Values

2-7
dummyheaddummyhead
SERVICE INFORMATION
OTHERS
STANDARD TORQUE VALUES
Item
Thread Dia. and pitch Torque values
Remarks
mm (in) N·m kgf·m lbf·ft
Neutral switch nut M20 x 1.0 2.5 0.26 1.8
Starter motor B terminal nut M8 x 1.25 11 1.1 8
PGM-FI/Main relay bolt M6 x 1.0 5 0.51 3.7
Connector bracket C bolt M6 x 1.0 5 0.51 3.7
Front separator cover bolt M6 x 1.0 (Special bolt) 10 1.0 7
Front separator cover bolt M6 x 1.0 (SH bolt) 5 0.51 3.7
Plug maintenance cover bolt M6 x 1.0 (SH bolt) 5 0.51 3.7
Engine under cover bolt M6 x 1.0 10 1.0 7
Under cover rear bracket bolt M6 x 1.0 (Special bolt) 5 0.51 3.7
Water joint cap nut M16 x 1.0 1.1 0.11 0.8 Apply locking agent to
the seating surface.
MAP sensor screw M6 x 1.0 3.4 0.35 2.5
Item
Thread Dia. (mm) and
pitch (length)
Torque values
N·m kgf·m lbf·ft
Screw 5 mm 4.2 0.43 3.1
6 mm 9 0.92 6.6
Bolt and nut 5 mm 5.2 0.53 3.8
6 mm 10 1.0 7
8 mm 21.5 2.2 16
10 mm 34 3.5 25
12 mm 54 5.5 40
Flange bolt and nut 6 mm (SH bolt) 10 1.0 7
6 mm (CT bolt) 12 1.2 9
6 mm 12 1.2 9
8 mm 26.5 2.7 20
10 mm 39 4.0 29
·SH bolt: Small head bolt
·CT bolt: Self-tapping bolt