TOHATSU BFT75A - Engine Cover Removal; Installation

6-3
dummyheaddummyhead
ENGINE COVER
ENGINE COVER REMOVAL/
INSTALLATION
REMOVAL
Unlock the locks on the front and rear sides of the engine cover and remove the engine cover.
INSTALLATION
Apply glue (LOCTITE
®
460 or equivalent) to the engine
cover seal [1] at the points shown.
• Note that the application points for the glue agent on
the inner side and outer side of the engine cover
seal are different.
Install the engine cover seal on the engine cover.
Set the engine cover on the outboard motor, and lock
the engine cover on the front and rear sides.
ENGINE COVER
ENGINE COVER SEAL
[1]
Glue (LOCTITE
®
460 or equivalent)
Application points (Outer side: At 8 points)
Inner side:
Glue (LOCTITE
®
460 or equivalent)
Application points (Inner side: Circumference)
Outer side: