TOHATSU BFT75A - Combination Switch Inspection

19-45
dummyheaddummyhead
CONTROLS
Clean the housing and under cover mating surfaces
thoroughly using a shop towel and degreasing cleaning
solvent.
Apply liquid gasket (ThreeBond® #1216E or equivalent)
to the housing in the areas shown.
Install the under cover [1] and six screws [2] and tighten
them to the specified torque.
Install the tiller handle (page 19-22).
COMBINATION SWITCH INSPECTION
Check for continuity between the terminals with the
switch in each position.
9 mm
(0.4 in)
20 mm
(0.8 in)
TORQUE: 2.4 N·m (0.24 kgf·m, 1.8 lbf·ft)
[2]
[1]
Black/Red
Black
Black/
Yellow
White/
Black
Black/
White
OFF
E
Black
IG
Black/
Red
BAT
White/
Black
LOAD
Black/
Yellow
ST
Black/
White
START
ON
Color
Position
: Continuity