TOHATSU BFT75A - Assembly; Under Cover Rear Bracket Disassembly;Assembly

6-18
dummyheaddummyhead
ENGINE COVER
R. ENGINE UNDER COVER DISASSEMBLY/ASSEMBLY
Remove the L./R. engine under cover (page 6-5).
Remove the nut [1] and water joint cap [2].
Remove the switch stay [3] and power trim/tilt switch [4].
Install the water joint cap on the R. engine under cover [5].
Apply locking agent to the seating surface of the nut and tighten it to the specified torque.
Install the power trim/tilt switch on the R. engine under cover with the "UP" mark toward up.
Check that the retaining tab [6] of the power trim/tilt switch hooks against the power trim/tilt switch stay
securely.
UNDER COVER REAR BRACKET DISASSEMBLY/ASSEMBLY
Remove the under cover rear bracket (page 6-15).
TORQUE: 1.1 N·m (0.11 kgf·m, 0.8 lbf·ft)
[1]
[2]
[3]
[4]
[5]
[6]
(Seating surface)
UNDER CASE GROMMET (2)
WATER CHECK
GROMMET
CASE COLLAR (2)
IDLE EXHAUST PORT
CLIP NUT
UNDER COVER
REAR BRACKET