3-33
dummyheaddummyhead
MAINTENANCE
CONTROL ADJUSTMENT
1. Move the control lever to the "N" (Neutral) position.
2. Loosen the shift pivot lock nut [1] of the remote
control cable (shift side) [2] and remove the shift
pivot [3] from the shift link pin [4].
3. Move the control lever [1] to the "F" (Forward)
position [2] and return it to the "N" (Neutral) position
[3] slowly.
4. While holding the shift control cable [4] and the
control lever in the position described in step 3, mark
(A) [5] at the end of the cable outer seal [6] on the
inner cable.
5. Move the control lever [1] to the "R" (Reverse)
position [2] and return it slowly to the "N" (Neutral)
position [3].
6. While holding the control lever in the position
described in step 5, mark (B) [4] at the end of the
cable outer seal on the inner cable.
7. Mark (C) [1] at the midpoint between the mark (A) [2]
and the mark (B) [3] on the inner cable.
To Next Page
