TOHATSU BFT75A - Page 112

3-35
dummyheaddummyhead
MAINTENANCE
13.Move the control lever from the "F" (Forward) to the
“N” (Neutral) position. If the gear does not shift to
neutral, disconnect the shift control cable from the
shift link pin. Move the inner cable toward the mark
(A) [1] and repeat the procedure from step 9.
14.Move the control lever from the "R" (Reverse) to the
"N" (Neutral) position. If the gear does not shift to
neutral, disconnect the shift control cable from the
shift link pin. Move the inner cable toward mark (B)
[1] and repeat the procedure from step 9.
15.After adjustment, move the control lever to each
gear position. If the gear does not shift to neutral
properly, repeat step 11 or step 12.
16.After installation, tighten the shift pivot lock nut [2].
[1]
Adjustment range
[1]
Adjustment range
[2]