TOHATSU BFT75A - Page 213

5-72
dummyheaddummyhead
FUEL SYSTEM
Install the three harness band clips [1] in the positions
shown.
Set the pressure regulator control tube [1] and the vinyl
tube [2] to the intake manifold.
Connect the TP sensor 3P connector [1].
Connect the MAP sensor 3P connector [1], and install
the harness band clip [2] on the set plate.
Install the following:
– Silencer case (page 5-68)
– Engine cover
[1]
[1]
[2]
[1]
[1]
[2]