TOHATSU BFT75A - Page 449

16-20
dummyheaddummyhead
GEAR CASE
Remove the circlip [1] from the shift slider [2].
Remove the roller [1] from the shift slider [2] using a
commercially available pin driver [3].
• Take care not to let the shift springs and the steel
balls pop out of the shift slider during removal of the
roller.
Remove the shift plate [1] from the shift slider [2], and
then remove the two shift springs [3] and the two steel
balls (#11) [4].
• Take care not to let the shift springs and the steel
balls pop out of the shift slider during removal of the
shift plate.
[1]
[2]
[2]
[1]
[3]
[4]
[2]
[1]
[3]