TOHATSU BFT75A - Page 455

16-26
dummyheaddummyhead
GEAR CASE
Set a commercially available universal bearing puller [1]
between the taper bearing (inner race) and forward
bevel gear.
Drive the taper bearing (inner race) out of the forward
bevel gear using the special tools and a hydraulic press
as shown.
Remove the taper bearing (outer race) [1] using the
special tool as shown.
Replace the taper bearing (outer race) and the inner
race with new ones as a set on assembly.
Remove the forward bevel gear shim [5] from the gear
case.
Replace the shim with a new one on assembly.
TOOLS:
Driver [2] 07749-0010000
Attachment, 42 x 47 mm [3] 07746-0010300
Pilot, 25 mm [4] 07746-0040600
[2]
[3]
[4]
[1]
TOOLS:
Bearing race puller [2] 07LPC-ZV30101
Remover handle [3] 07936-3710100
Remover weight [4] 07936-371020A
[2]
[5]
[4]
[3]
[1]