18-14
dummyheaddummyhead
TRIM/TILT
Set the lead wire [1] between the projections [2] on the
anode metal [3], and install them with the two bolts [4].
Tighten the bolts.
• Before installation, check the anode metal for
corrosion and replace it with a new one if necessary.
Set the lead wire as shown and install the screw [5].
Tighten the screw.
Route the trim angle sensor wire [1] and the power tilt
motor wire [2] through under case grommet C [3].
Align the end of the taped part [4] of the power tilt motor
wire with the end [5] of under case grommet C and
secure with the new tie-wrap band [5].
Cut off any excess tie-wrap band.
Loosen the manual valve [1] fully.
Raise the swivel case a little, unlock the tilt stopper, and
lower the swivel case to the lowermost position.
Tighten the manual valve to the specified torque.
Install the following:
– Mount case (page 17-2)
– Engine (page 13-8)
TORQUE: 3.4 N·m (0.35 kgf·m, 2.5 lbf·ft)
To Next Page
