18-17
dummyheaddummyhead
TRIM/TILT
Remove the three grease fittings [1] from the swivel
case [2].
Remove the two self-locking nuts [3], washers [4], and
thrust receivers [5].
Remove the bolt [1], detent spring [2], and detent
assisted spring [3].
Using a commercially available pin driver (2.5 mm) [4],
drive out the spring pin (2.5 X 20 mm) [5] up to the
position where if does not interfere with the swivel case.
Remove the spring pin (2.5 X 20 mm) that was just
driven out using pliers or an equivalent tool.
Remove the spring pin located on the other side,
following the same procedure.
Remove the two tilt stoppers [6] and the tilting bracket
[7].
Check the cam and bearing of the tilting bracket for
wear, damage, or deformation. Replace the tilting
bracket with a new one if necessary.
Check the tilt arm bushings [8] on the swivel case for
wear, damage, or deformation. Replace the tilt arm
bushings with new ones if necessary.
Remove the two tilt arm bushings.
[1]
[3]
[7]
[2]
[5]
[6]
(8)
[6]
[8]
[4]
[5]
To Next Page
