19-11
dummyheaddummyhead
CONTROLS
INSTALLATION
Set the neutral switch [1] on the neutral switch bracket
[2] and tighten the nut [3] to the specified torque.
Set clip A [4] on the neutral switch wire and install clip A
on the neutral switch bracket.
Install the neutral switch bracket [1], aligning the two
holes [2] in the neutral switch bracket with the two
projections [3] on the crankcase as shown.
Tighten the bolt [4] securely.
Install the harness band clip [5] that clamps the fuse
cable on the neutral switch bracket.
Connect the neutral switch 2P connector [6] and install
the connector on the neutral switch bracket.
Apply marine grease the following part.
– Shift shaft spline portion
– Detent spring roller/link pin contact portion
Install the shift arm [1] on the shift shaft, aligning the
projection on the shift arm [2] with the recess in the shift
shaft [3] as shown.
Set the snap pin [4] on the shift shaft securely as
shown.
TORQUE: 2.5 N·m (0.26 kgf·m, 1.8 lbf·ft)
To Next Page
Loading...
