WASHER (5 mm)
SCREW
(5 X 10 mm)
WASHER (6 mm) (2)
NUT (5 mm)
BOLT
(5 X 16 mm)
SLIDING PLATE
“UP” MARK
PLATE COLLAR
SLIDING PLATE/PLATE COLLAR
INSTALLATION:
Install the sliding plate with the “UP”
mark facing up.
Attach the sliding plate collar to the
sliding plate with its wider side toward
the “UP” mark of the sliding plate.
CONTROL WHEEL
PIN (6 X 6 mm)
WASHER (6 mm)
FAST IDLE DETENT
SPRING (12.7 X 23.9 mm)
SPRING
SETTING PLATE
SCREW (5 X 10 mm)
FAST IDLE DETENT
ROLLER (13 X 13 mm)
FAST IDLE WHEEL
LINK JOINT ARM
LINK JOINT
COLLAR (2)
SCREW (6 X 10 mm)
WASHER (8 mm)
E-CLIP (7 mm)
E-CLIP (4 mm)
FAST IDLE SPRING
4.9 N·m (0.50 kgf·m,
3.6 lbf·ft)
5.9 N·m (0.60 kgf·m,
4.4 lbf·ft)
LINK JOINT
BRACKET
INSTALLATION:
Install in the concave area of the
control wheel as shown.
2.5 N·m (0.26 kgf·m, 1.8 lbf·ft)
To Next Page
