3-7
dummyheaddummyhead
MAINTENANCE
ADDING
Place the outboard motor on a level surface and
position the outboard motor vertically (with the engine
level).
Remove the oil check bolt [1] and oil drain plug bolt [2],
and then check for metal particles on the magnet end
[3].
If there are metal particles on the magnet end of the
drain plug bolt, disassemble and inspect the gear case
(page 16-5).
Install a commercially available gear case filler (STV-
S33) [4] and filler adapter (STV-334Y) [5] in the oil drain
plug hole, and add gear oil until it flows out from the oil
check bolt hole.
After adding gear oil, remove the gear oil pump.
Apply gear oil to new O-rings [6] and install them on the
oil level check bolt and drain plug bolt.
Install and tighten the bolts to the specified torque.
GEAR OIL CAPACITY:
0.95 liters (1.00 US qt, 0.84 Imp qt)
RECOMMENDED GEAR OIL:
MARINE SAE 90 Hypoid gear oil
API Service Classification (GL-4)
TORQUE: 6.5 N·m (0.66 kgf·m, 4.8 lbf·ft)
To Next Page
Loading...
