Toro Groundsmaster 360 - Page 189

InstallingtheCrossTraxTractionManifoldAssembly(continued)
g036302
Figure134
1.Tractionmanifoldassembly
3.HosetoportLR
2.Transmission4.HosetoportRR
1.Ifanoricewasremovedfromanyport,ensurethattheoriceisinthe
portbeforeyouinstallthetting;refertoServicingtheCrossTraxTraction
ManifoldAssembly(page4–132).
2.Ifthehydraulicttingswereremovedfromthetractionmanifoldassembly,
lubricatenewO-ringswithcleanhydraulicuid,positiontheO-ringstothe
ttings,andinstallthettingsintotheports;refertoInstallingtheHydraulic
Fittings(SAEStraightThreadO-RingFittingintotheComponentPort)(page
4–9).
3.Positionthetractionmanifoldassemblytothemachine.
4.Positionthe2washers(item9inFigure133)tothetopofthemounts.
Securethetractionmanifoldassemblytothemachinewith2boltsand2
washers(item7inFigure133).
5.Removethecapsandplugsfromthehydraulichosesandttings.
Note:ThehosesinportsLRandRRshouldbeinstalledinthetraction
manifoldportsbeforetheyareinstalledtothehydraulictubes.
6.Usethelabelsthatyouattachedduringtractionmanifoldassemblyremoval,
correctlyconnectthehydraulichosestothetractionmanifoldassemblyand
hydraulictubes(Figure134);refertoInstallingtheHydraulicHoseandTube
(O-RingFaceSealFitting)(page4–8).
7.Checkthehydraulic-uidlevelinthehydraulicreservoirandaddcorrect
quantityofuidifnecessary;refertotheOperator’sManual.
8.Lowerandsecuretheoperatorseat.
Groundsmaster360
Page4–131
HydraulicSystem:ServiceandRepairs
16225SLRevC