Toro Groundsmaster 360 - Page 225

RemovingtheLiftCylinder(continued)
6.Installcleancapsorplugsinthehoseopeningstopreventsystem
contamination.
7.Removetheretainingring(item3inFigure153)andwasherfromoneendof
thecylindershaftthatsecurestheliftcylinderheadtothemachineframe.
8.Pulltheshaftfromtheliftcylinderandframe.Locateandretrievethesecond
washer.Donotremovesecondretainingringfromtheshaft.
9.Removetheshoulderbolt(item6inFigure153)andpivotpin
thatsecuretheliftcylinderrodendtotheliftshaftassembly.
10.Removetheliftcylinderfromthemachine.
11.Ifnecessary,removethehydraulicttingsfromtheliftcylinder(Figure154).
12.RemoveanddiscardtheO-ringsfromthettings.
InstallingtheLiftCylinder
1.Ifthehydraulicttingswereremovedfromtheliftcylinder,lubricateandinstall
newO-ringstothettings.Installthettingsintotheliftcylinderportsand
torquethettingsto20to25N∙m(15to19ft-lb).
2.Positiontheliftcylindertothemachine.
Note:Thecylinderheadshouldbeattachedtothemachineframe.
3.Securethecylinderrodendtotheliftshaftassemblywiththepivotpin(item
4inFigure153)andshoulderbolt.
4.Aligntheliftcylindertotheframemountingholes.Slidethecylindershaft
(item1inFigure153)(withawasherandretainingringinstalledontheone
end)throughtheliftcylinderandframe.Installthesecondwasheronthe
shaftandsecuretheshaftwiththesecondretainingring.
5.Removethecapsorplugsthatwereinstalledtothehydraulichosesduring
theremovalprocess.
6.Usethelabelsthatyouattachedduringtheliftcylinderremovaltocorrectly
connectthehydraulichosestotheliftcylinderttings;refertoInstallingthe
HydraulicHoseandTube(O-RingFaceSealFitting)(page4–8).
7.Lubricatethegreasettingsontheliftcylinderandpivotpin.
8.Ensurethatthehydraulictankisfull.Addcorrectquantityofuidifnecessary;
refertotheOperator’sManual.
Groundsmaster360
Page4–167
HydraulicSystem:ServiceandRepairs
16225SLRevC