Toshiba e-STUDIO6520c - Page 124

e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
2 - 86
363 Scanner Data transfer of
characteristic value of
scanner / SYS board →
SLG board
SCN - SYS Transfers the
characteristic values of
the scanner (shading
correction factor / RGB
color correction /
reproduction ratio color
aberration correction /
shading position
correction factor /
reproduction ratio
correction value in
primary scanning
direction) from the
SRAM of the SYS
board to the SRAM of
the SLG board.
6
364 Scanner Data transfer of
characteristic value of
scanner / SLG board →
SYS board
SCN - SYS Transfers the
characteristic values of
the scanner (shading
correction factor / RGB
color correction /
reproduction ratio color
aberration correction /
shading position
correction factor /
reproduction ratio
correction value in
primary scanning
direction) from the
SRAM of the SLG
board to the SRAM of
the SYS board.
6
365 RADF RADF leading
edge position
1 adjustment
Front side ALL 50
<0-100>
SYS When the value
increases by “1”, the
copied image of original
fed from the RADF
shifts toward the trailing
edge of paper by
approx. 0.2 mm.
1
366 Back side ALL 50
<0-100>
SYS 1
Adjustment mode (05)
Code
Classific
ation
Items
Functi
on
Default
<Accept
able
value>
RAM Contents
Proce
dure