3
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
ADJUSTMENT
3 - 63
3.4.8 RGB conversion method selection
The color space conversion method of image is decided at color-scanning.
<Adjustment Mode (05)>
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in the codes and press the [START] button.
(3) Key in the adjustment values. Acceptable values: 0 to 3. (To correct the value once keyed in,
press the [CLEAR] button.)
(4) Press the [ENTER] or [INTERRUPT] button to store the value in memory.→ The equipment goes
back to the ready state.
(5) Let the equipment restart and perform the scanning job.
(6) If the desired image has not been attained, repeat step (1) to (5).
3.4.9 Adjustment of saturation
The brightness of the scanned image is adjusted at color-scanning.
<Adjustment Mode (05)>
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in the codes and press the [START] button.
(3) Key in the adjustment values. Acceptable values: 0 to 255.
(To correct the value once keyed in, press the [CLEAR] button.)
(4) Press the [ENTER] or [INTERRUPT] button to store the value in the memory. → The equipment
goes back to the ready state.
(5) Let the equipment restart and perform the scanning job.
(6) If the desired image has not been attained, repeat step (1) to (5).
Code Original mode Remarks
1080 Text 0: sRGB, 1: AppleRGB, 2: ROMMRGB, 3: AdobeRGB
(Default: 0)
1081 Printed Image
1082 Photo
8372 User custom
Code Original mode Remarks
8325 Text The larger the value is, the brighter the image becomes.
The smaller the value is, the duller the image becomes.
Acceptable values: 0 to 255 (Default: 128)
8326 Printed Image
8327 Photo
8373 User custom
To Next Page
Loading...
