Toshiba e-STUDIO6520c - Adjustment of the Scanner Section

e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 70
3.7 Adjustment of the Scanner Section
3.7.1 Adjustment carriages-1 and -2 positions
(1) Move the carriage-2 toward the exit side.
(2) Loosen the screws fixing the front side pulley
bracket, make the sections A and B of the
carriage-2 touch with the inside of the exit
side frame and screw them up.
Fig. 3-30
(3) Put the carriage-1 on the rail, make the
sections C and D of it touch with the inside of
the exit frame and screw up the front/rear
side of the bracket to fix it.
Note:
Make sure that the sections A and B of the
carriage-2 touch with the exit side frame.
Fig. 3-31
B
A
Carriage-2
Pulley bracket
Exit side frame
Enlarged view of carriage
[
Rear
] [Front]
Carriage-1
[
Rear
]
[
Front
]
D
C
Bracket
Bracket
Exit frame
Enlarged view of carriage