Toshiba e-STUDIO6520c - Adjustment of the Reversing Automatic Document Feeder (RADF)

e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 72
3.8 Adjustment of the Reversing Automatic Document Feeder
(RADF)
3.8.1 RADF position adjustment
Perform this adjustment when the RADF is removed.
(1) Place the RADF aligning its installation
shoulder screw with the hole of the hinge
bracket, and then slide it to the front side.
Fig. 3-34
(2) Tighten the 2 fixing screws of the hinge
bracket (front side) temporarily.
Fig. 3-35
(3) Remove the platen sheet.
Note:
Be sure not to fold or stain the removed
platen sheet.
Fig. 3-36