Toshiba e-STUDIO6520c - Maintenance Part List

e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
PREVENTIVE MAINTENANCE (PM)
5 - 48
5.9 Maintenance Part List
The parts used for the maintenance of this equipment are as follows.
No. Item Purpose
Parts list
<P-I>*1
1 Cleaning brush Cleaning inside of the equipment 201-1
2 Doctor blade cleaning jig*2 Cleaning the doctor blade 201-7
3 Wire holder jig Fixing the wire at the assembly of the carriage wire 201-2
4 RADF positioning pin Determining the position of the RADF 201-5
5 Doctor-sleeve jig Measuring the gap between the development sleeve
and the doctor blade
201-6
6 Belt tension jig Adjusting the belt tension at the installation of the
scan motor
201-3
7 Separation plate gap jig*2 Measuring the gap between the separation plate and
the fuser belt
201-11
8 Thermostat gap confirmation jig*2 Measuring the gap between the thermostat and the
fuser belt, and the thermostat and the pressure roller
201-9
9 Thermistor gap confirmation jig*2 Measuring the gap between the thermistor and the
pressure roller
201-10
10 Drum bag Storing the drum 201-4
11 Download jig (DLM board) Updating the scanner/options ROM 202-1
12 ROM Installing the DLM board 202-10
13 Download jig-2 (6 Flash ROMs) Updating the system/engine ROM 202-2
14 ROM writer adapter (For 1881) Writing the data of PWA-DWNLD-350-JIG2 202-4
15 ROM writer adapter (For 1931) Writing the data of PWA-DWNLD-350-JIG2 202-5
16 Toner seal plate*2 Preventing foreign matter from entering into the toner
supply opening (for transporting the unpacked
equipment)
201-8
*1: Part list <P-I> represents the page item in “e-STUDIO5520C/6520C/6530C Service Parts List”.
*2: This part has been newly added in e-STUDIO5520C/6520C/6530C, others are common to those
used for other models.