Toshiba e-STUDIO6520c - Belt Tension Adjustment of the Scan Motor

3
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
ADJUSTMENT
3 - 71
3.7.2 Belt tension adjustment of the Scan motor
(1) Hook the belt tension jig to the motor bracket
and the flame.
(2) Loosen screw-A and -C. (There is no need to
loosen screw-B, since it is a shoulder screw.)
(3) The scan motor is pulled by the belt tension
jig. Fix screw-A and then -C at the stopped
position.
(4) Remove the belt tension jig.
Fig. 3-32
Fig. 3-33
C
A
B
Pully
Timing belt
Scan motor
Belt tension jig
Belt tension jig