Toshiba e-STUDIO6520c - General Descriptions for PM Procedure

5
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
PREVENTIVE MAINTENANCE (PM)
5 - 5
5.3 General Descriptions for PM Procedure
(1) Preparation
• Ask the user about the current conditions of the equipment and note them down.
• Before starting maintenance, make some sample copies and store them.
• See the replacement record and check the parts to be replaced in the PM support mode (6S-
2) or list printing mode (9S-103).
6S-2 : [6] + [START] + [POWER] ON Æ [2] Æ [START]
9S-103 : [9] + [START] + [POWER] ON Æ [103] Æ [START]
Fig. 5-1
• Turn OFF the power and make sure to unplug the equipment.
(2) Perform a preventive maintenance using the following checklist and illustrations.
(3) Plug in the equipment after the maintenance has been finished. Then turn ON the power and
make some copies to confirm that the equipment is working properly.
PM SUPPORT CODE LIST
MM-DD-YY HH:MM
UNIT OUTPUT PAGES/ PM OUTPUT PAGE/ DRIVE COUNTS PM DRIVE COUNTS
DEVELOP COUNTS DEVELOP COUNTS
DRUM(K) 342 70000 4377 130000
DRUM BLADE(K) 342 70000 4377 130000
DRUM BRUSH(K) 342 70000 4377 130000
GRID(K) 342 70000 4377 130000
MAIN CHARGER NEEDLE(K) 342 70000 4377 130000
CHARGER CLEANING PAD(K) 177 70000 3681 130000