Toshiba e-STUDIO6520c - Paper Feeding System Related Service Call

e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
6 - 74
6.2.12 Paper feeding system related service call
[C130] 1st drawer tray abnormality
[C140] 2nd drawer tray abnormality
Does the tray go up? (Perform the output check: 03-246, 247)
|
|
|
|
|
|
|
|
È
NO Æ 1. Check if the connector of the tray-up motor is disconnected.
2. Check if the connector CN508 on the PFC board is disconnected.
3. Check if the connector pins are disconnected or the harnesses are open
circuited.
4. Check if the conductor pattern on the PFC board is short circuited or open
circuited.
5. Replace the tray-up motor.
6. Replace the PFC board.
YES
Is the tray-up sensor working? (Perform the input check: 03-[Copy ON]/[9]/[H], /[9]/[G])
|
|
|
|
|
|
|
|
|
|
È
NO Æ 1. Check if the connector of the sensor is disconnected.
2. Check if the connector CN513 on the PFC board is disconnected.
3. Check if the slit reaches the sensor.
4. Check if the connector pins are disconnected or the harnesses are open
circuited.
5. Check if the conductor pattern on the PFC board is short circuited or open
circuited.
6. Replace the tray-up sensor.
7. Replace the PFC board.
YES
1. Check if the conductor pattern on the PFC board is short circuited or open circuited.
2. Replace the PFC board.