Toshiba e-STUDIO6520c - 2 Self-Diagnostic Mode

2
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
SELF-DIAGNOSTIC MODE
2 - 1
2. SELF-DIAGNOSTIC MODE
Note:
To enter the desired mode, turn the power ON while pressing two digital keys designated to each
mode (e.g. [0] and [5]) simultaneously. Hold the two keys until the [COPY] [e-FILING] [SCAN]
[PRINT] [FAX] buttons are lit.
• Control panel check mode (01):
<Operation procedure>
Notes:
1. A mode can be cancelled by [POWER] OFF/ON when the LED is lit and the LCD is blinking.
2. Button Check
Buttons with LED (Press to turn OFF the LED.)
Buttons without LED (Press to display the message on the control panel.)
Button on touch panel (Press to display the initial screen displayed at power-ON.
Press [execution] on the touch panel and then
the [CLEAR] button on the control panel.
The screen then returns to the Button Check menu.)
• Test mode (03): Refer to  P.2-4 "2.1 Input check (Test mode 03)" and  P.2-15 "2.2 Output check
(test mode 03)".
• Test print mode (04): Refer to  P.2-22 "2.3 Test print mode (test mode 04)".
• Adjustment mode (05): Refer to  P.2-35 "2.5 ADJUSTMENT MODE (05)".
• Setting mode (08): Refer to  P.2-116 "2.6 SETTING MODE (08)".
Mode For start Contents For exit Display
Control panel
check mode
[0] + [1] +
[POWER]
All LEDs on the control panel are lit, and all
the LCD pixels blink.
[POWER]
OFF/ON
-
Test mode [0] + [3] +
[POWER]
Checks the status of input/output signals. [POWER]
OFF/ON
100% C A4
TEST MODE
Test print mode [0] + [4] +
[POWER]
Outputs the test patterns. [POWER]
OFF/ON
100% P A4
TEST PRINT
Adjustment
mode
[0] + [5] +
[POWER]
Adjusts various items. [POWER]
OFF/ON
100% A A4
TEST MODE
Setting mode [0] + [8] +
[POWER]
Sets various items. [POWER]
OFF/ON
100% D
TEST MODE
List print mode [9] + [START] +
[POWER]
Prints out the data lists of the codes 05 and
08, PM support mode, pixel counter, error
history, firmware upgrade log and power ON/
OFF log, and also outputs them in a CSV
format.
[POWER]
OFF/ON
100% L A4
LIST PRINT
PM support
mode
[6] + [START] +
[POWER]
Clears each counter. [POWER]
OFF/ON
100% K
TEST MODE
Firmware
update mode
[8] + [9] +
[POWER]
Performs updating of the system firmware. [POWER]
OFF/ON
-
To exit from Adjustment mode and Setting mode:
Shut down the equipment. When the power should be turned OFF, be sure to shut down the
equipment by pressing the [ON/OFF] button for a few seconds.
[0][1]
[POWER]
LED lit/
LCD blinking
[START]
[START]
(Button check)
[POWER] OFF/ON
(Exit)