3
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
ADJUSTMENT
3 - 53
3.3.6 Maximum toner density adjustment (OHP)
The maximum toner amount adhering can be controlled.
<Adjustment Mode (05)>
<Procedure>
The procedure is the same as that of P.3-52 "3.3.4 Adjustment of faint text".
The larger the value is, the more frequently fusing offsetting occurs.
3.3.7 Fine line enhancement switchover
<Adjustment Mode (05)>
<e-Bridge>
<EFI>
<Procedure>
The procedure is the same as that of P.3-49 "3.3.2 Gamma balance adjustment (Black Mode)".
3.3.8 “PureBlack/PureGray” threshold adjustment (PS)
<Adjustment Mode (05)>
<Procedure>
The procedure is the same as that of P.3-49 "3.3.2 Gamma balance adjustment (Black Mode)".
Code Paper type Remarks
1050 OHP film
(600dpi)
The smaller the value is, the toner amount adhered decreases of the high
density area (ex. prevention of fusing offsetting, etc.).
Acceptable values: 0 to 255
8149 OHP film
(1200dpi)
Black mode Color mode
Remarks
PS PCL XPS PS PCL XPS
7322-0 7322-1 7322-2 8102-0 8102-1 8102-2 Whether fine lines are enhanced or not can be
switched.
0: OFF
1: ON (default)
Black mode Color mode
Remarks
PS PCL XPS PS PCL XPS
7323-0 7323-1 7323-2 8103-0 8103-1 8103-2 Whether fine lines are enhanced or not can be
switched.
0: OFF
1: ON (default)
Original mode
Item to be
adjusted
Remarks
General
Photogra
phic
Presentat
ion
Line art Advanced
8252-0 8252-1 8252-2 8252-3 8252-4 Text The larger the value is, the wider
the color range to be printed only
with the black toner becomes. The
smaller the value is, the narrower
this color range becomes.
Acceptable values: 1 to 255
8253-0 8253-1 8253-2 8253-3 8253-4 Graphics
8254-0 8254-1 8254-2 8254-3 8254-4 Image
To Next Page
Loading...
Need help?
General
