Toshiba e-STUDIO6520c - Adjusting the Clearance of the Paper and Side Guides

e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 94
<In the case of bypass feeding>
(1) Move the side guides halfway to the center.
3.9.4 Adjusting the clearance of the paper and side guides
If the clearance between the paper and the side guides is too wide, it can be adjusted to between 0 and
1 mm (the clearance between the paper and the guides is 1 to 2 mm (including both front and rear
sides))
<Procedure>
(1) Take off the drawer.
(2) Loosen 1 screw.
(3) Move the rear side guide to the front or rear
side.
* The position of the screw is adjustable
within the diameter of the long screw
hole; from - 3 mm to + 3 mm.
(4) Fix the 1 screw.
Note:
The paper transport position is moved the
same amount and direction as the side
guide.
Fig. 3-88
(2) Lift up the paper tray and let it run up onto
the stopper in the front of the drawer. Then
lift it up further to remove it.
Fig. 3-89
(3) Set the side guide to the 12 inch mark.
Fig. 3-90
Stopper
Drawer paper tray