3
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
ADJUSTMENT
3 - 93
* Table of the adjustment combination of the gear holder and the side guide adjustment piece
Fig. 3-87
1. Be sure that the moving amount of the
gear holder and the side guide
adjustment piece is the same. If it is
different, it could cause a drawer
automatic size detection defect.
2. Do not tighten the screw too much. The
side guide adjustment piece could
disengage the groove, making correct
adjustment impossible.
Fig. 3-86
Side guide adjustment piece
3 mm
2 mm
1 mm
Moved
by
Transport position moved to the
rear side
Transport position moved to the
front side
Default
To Next Page
Loading...
