e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 92
[B] Adjustment of the gear holder
[C] Adjustment of the rear side guide
(3) Lift up the drawer paper tray.
(4) Take off the drawer tray upward by releasing
it from a stopper on the front side.
Fig. 3-83
(1) Rotate 2 screws fixing the gear holder about
half a turn to loosen it.
(2) Move the rear side guide to the front and rear
sides while slightly lifting up the gear holder
so that it can be moved.
(3) Move the gear holder matching with the
scales, and tighten the screw. (Be sure that
the teeth of the gear are securely engaged
when you are moving the gear holder.)
* The paper transport position is moved the
same amount and direction as the gear
holder.
The acceptable moving amount is from -3
mm to +3 mm, in increments of 1 mm.
Fig. 3-84
(1) Adjust the end guide to the size of A4-R.
(2) Rotate the screw fixing the side guide
adjustment piece about half a turn to loosen
it.
(3) Move the side guide adjustment piece the
same amount as the paper transport position
and in the opposite direction to the one of the
paper transport position, and then fix it with a
screw.
* For example, if you move the paper
transport position to the rear side by 1
mm, you must move the side guide
adjustment piece to the front side by 1
mm and fix it.
* If you move the paper transport position
to the front side by 1 mm, you must move
the side guide adjustment piece to the
rear side by 1 mm and fix it.
Fig. 3-85
Stopper
Drawer paper tray
FrontRear
Screw
Gear holder
FrontRear
Screw
Side guide adjustment piece
(back side)
To Next Page
Loading...
