3
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
ADJUSTMENT
3 - 15
3.1.7 Printer-related image dimensional adjustment
The printer related adjustment is performed by using the printed out grid pattern.
Fig. 3-14
Adjustment
Tolerance
Detail of adjustment
A 200 ± 0.5mm Refer to “[A] Reproduction ratio of primary scanning direction (Image clock fine
adjustment (Printer))”
B 52 ± 0.5mm Refer to “[B] Image position of primary scanning direction (Laser writing start
position (Printer))”
C 200 ± 0.5mm Refer to “[C] Reproduction ratio of secondary scanning direction (Fine adjustment
of transfer belt motor rotation speed (Printer))”
D 52 ± 0.5mm Refer to “[D] Image position of secondary scanning direction (Laser writing start
position)”
E 52 ± 0.5mm Refer to “[E] Primary scanning data laser writing start position at duplexing”
A
21
6
1
B, E
D
C
6
2
22
Feeding direction
To Next Page
Loading...
