e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 84
3.8.7 RADF opening/closing switch adjustment
Adjust the bracket position so that the sensor is turned ON when the height “J” becomes 145 mm or
less (within the empty weight falling limit).
Fig. 3-67
(1) Take off the RADF rear cover.
Service Manual “16.5.3 RADF rear cover”
(2) Loosen the fixing screw of the bracket. Slide
the bracket vertically using the scale as a
guide to adjust the position where the switch
is turned ON.
(3) Tighten the fixing screw of the bracket. Install
the RADF rear cover.
Fig. 3-68
J
Scale
Bracket
Screw
To Next Page
Loading...
