Toshiba e-STUDIO6520c - Page 271

3
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
ADJUSTMENT
3 - 73
(4) Remove 2 gaskets.
Fig. 3-37
(5) Remove 2 screws.
Fig. 3-38
(6) Install 2 positioning pins.
Fig. 3-39
(7) Close the RADF gently and check if the
positioning pins fit the holes on the RADF.
Fig. 3-40