3
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
ADJUSTMENT
3 - 69
(4) Insert the gauge “0.60” of the doctor-sleeve
jig into the gap between the developer
sleeve and the doctor blade and make sure
that the gauge can move smoothly in the
front/rear direction. In addition, confirm that
the gauge “0.70” cannot be inserted into the
gap.
Fig. 3-29
0.60 mm
0.70 mm
Doctor-sleeve gap jig
Doctor blade
To Next Page
Loading...
