Toshiba e-STUDIO6520c - Page 201

3
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
ADJUSTMENT
3 - 3
(7) After 2 min. have passed, the following screen is displayed and the auto-toner adjustment starts.
During the adjustment, “Current sensor voltage (V)” shown in B automatically changes and
gradually approaches the “Target value (V) for the adjustment reference voltage” shown in A.
Fig. 3-5
(8) When the “Current sensor voltage (V)” in (B) is converged and the “Sensor output control value
(bit value)” corresponding to the value for initial developer material is displayed in (C), the
adjustment is completed.
When the adjustment is completed, the [ENTER] button is displayed on the screen.
Fig. 3-6
Note:
The values in (A), (B) and (C) vary with humidity.
(9) Press the [ENTER] button to store the adjustment result in the memory.
Note:
If you enter any of the codes 200, 201, 202, 203, 204 or 206 after pressing the [CANCEL] button
without pressing the [ENTER] button, or after auto-toner adjustment has failed, the operation in
step (7) starts without that in step (4) to (6).
(10) Turn the power OFF.
(11) Take out the developer cartridge.
(12) Install the sub-hopper unit to the equipment.
(
B
)
(
C
)
(
A
)
M: z.zzV C: z.zzV K: z.zzVY: z.zzV
M: x.xxV C: x.xxV K: x.xxVY: x.xxV
M: C: K: ww%Y:
(
B
)
: Current sensor voltage
(
V
)
(
A
)
: Target value
(
V
)
for adjustment reference voltage
(
C
)
: Adjustment value, Humidity (%)
(
B
)
(
C
)
(
A
)
M: z.zzV C: z.zzV K: z.zzVY: z.zzV
M: x.xxV C: x.xxV K: x.xxVY: x.xxV
M: yyy C: yyy K: yyyY: yyy
(
B
)
: Current sensor voltage
(
V
)
(
A
)
: Target value
(
V
)
for adjustment reference voltage
(
C
)
: Sensor output control value
(
bit value
)