e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 26
[E] Image location of secondary scanning direction
(1) While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)
(2) Place Test Chart No. TCC-1 on the original glass (with the arrow positioned at the left rear side).
(3) Press [FAX] → [START] to make a copy at the mode of A4/LT, 100%, Full color and Text/Photo.
(4) Measure the distance D from the top paper edge to the 10 mm line of top grid pattern on the copy
with a ruler.
(5) Check if the distance D is within 10±0.5 mm.
(6) If not, use the following procedure to change values and repeat step 3. to 5. above.
<Procedure>
(Adjustment Mode) → (Key in the code [305]) → [START]
→ (Key in a value (acceptable values: 68 to 188))
→ [ENTER] or [INTERRUPT] (Stored in memory)
* The larger the adjustment value is, the longer the distance D becomes (approx. 0.09 mm/
step).
To Next Page
Loading...
