e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 48
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON. → Adjustment Mode
(2) Select the A4/LT drawer. Key in the pattern number and press the [FAX] button to output a “Patch
chart for gamma adjustment”
However, this is applied to all paper types when 05-1008 (600dpi) or 05-1009 (1200dpi) is
performed.
(3) Place the patch chart for adjustment printed in step (2) face down on the original glass, with its
side, on which two black squares are present, aligned against the original scale.
(4) Key in a code and press the [START] button. → The scanner reads the chart automatically and
performs automatic gamma adjustment calculation.
(5) When the adjustment has finished normally, “ENTER” is shown.
Press the [ENTER] button to have the adjustment results reflected.
(To cancel the reflection of adjustment results, press the [CANCEL] button.)
In the case of an abnormal ending, “ADJUSTMENT ERROR” is shown. Press the [CANCEL]
button to clear the error display.
When it is cleared, the control panel display will return to the ready state. Then, check if the patch
chart on the original glass is placed in the wrong direction or if it is placed inclined on the original
glass, and then repeat step (3) and afterward.
Pattern No. Paper type Remarks
70 Plain paper 1 Used when the code 1004-0 is performed (600dpi)
72 Plain paper 2 Used when the code 1004-1 is performed (600dpi)
74 Recycled paper Used when the code 1004-2 is performed (600dpi)
76 Thick paper 1 Used when the code 1004-3 is performed (600dpi)
78 Thick paper 2 Used when the code 1004-4 is performed (600dpi)
80 Thick paper 3 Used when the code 1004-5 is performed (600dpi)
82 Thick paper 4 Used when the code 1004-6 is performed (600dpi)
84 Special paper 1 Used when the code 1004-7 is performed (600dpi)
86 Special paper 2 Used when the code 1004-8 is performed (600dpi)
230 Plain paper 1 Used when the code 1005-0 is performed (1200dpi)
232 Plain paper 2 Used when the code 1005-1 is performed (1200dpi)
234 Recycled paper Used when the code 1005-2 is performed (1200dpi)
236 Thick paper 1 Used when the code 1005-3 is performed (1200dpi)
238 Thick paper 2 Used when the code 1005-4 is performed (1200dpi)
240 Thick paper 3 Used when the code 1005-5 is performed (1200dpi)
242 Thick paper 4 Used when the code 1005-6 is performed (1200dpi)
244 Special paper 1 Used when the code 1005-7 is performed (1200dpi)
246 Special paper 2 Used when the code 1005-8 is performed (1200dpi)
Code Remarks
08-9059 0: No paper selecting buttons displayed
1: Paper selecting buttons displayed. (For both Copy and Printer)
To Next Page
Loading...
