4
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
BACKUP FUNCTION
4 - 13
<When “6: SRAM Data Restore” is selected>
(5) Press the [START] button. The restore starts and the restoring status is displayed on the LCD
screen.
(6) “Restore Completed” is displayed on the LCD screen when restoring has been properly
completed.
(7) Turn the power OFF and remove the USB media.
* When “department management data” or “user management data” are restored, clear their counter
values in a procedure below.
(8) Counter values can be all cleared as the data are copied. Note that the total counter values are
not copied.
<Procedure>
Press the buttons as follows: [COUNTER]Æ[DEPARTMANT MANAGEMENT]ÆEnter the
passwordÆ[RESET ALL COUNTERS]
* Enable the department management when the [RESET ALL COUNTERS] buttons is set to be
disabled.
Fig. 4-10
Number Restore Item
1. SRAM Restoring SRAM Data
* No items are selected in the screen by default.
Fig. 4-11
To Next Page
Loading...
