5
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
PREVENTIVE MAINTENANCE (PM)
5 - 37
* K1: 2nd transfer roller
Since the bearing is press-fitted in the bushing, be sure to remove it straight so that it does not fall
off.
Fig. 5-36
* K3: 2nd transfer roller side seal
Be sure to attach the 2nd transfer roller side seal according to the criteria in the figure below.
Part A: Pay attention to the following. If the blade is caught by the side seal or comes up on to it,
the blade may turn up. If the gap between the blade and the side seal is too wide, this will cause
toner scattering.
Fig. 5-37
After the side seals are attached, move the bracket retaining the blade and check that it is neither
caught nor comes up on to the side seal.
Fig. 5-38
2nd transfer roller
Bearing
Bushing
Bushing
Bearing
0~0.5 mm
0~0.5 mm
2nd transfer roller
cleaning blade
0~0.5 mm
A
A
A
2nd transfer roller side seal
2nd transfer roller
side seal (front)
Side seal
Blade
Normal
Side seal
Blade
Side seal
Blade
Being cought Coming up on
To Next Page
Loading...
