Toshiba e-STUDIO6520c - Page 41

2
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
SELF-DIAGNOSTIC MODE
2 - 3
Remark:
The buttons on the control panel keep blinking while data are being stored in the USB media.
• Do not disconnect the USB media while data are being stored.
• When the data of a code are printed again on the same equipment, the CSV file will be
overwritten because the names of these files contain the same serial number.
• PM support mode (6S):
<Operation procedure>
• Firmware update mode (89): Refer to  P.8-1 "8. FIRMWARE UPDATING".
• State transition diagram of self-diagnosis modes
Fig. 2-1
*1 Turn OFF the power after using the self-diagnosis mode, and leave the equipment to the user.
[6][START]
[POWER]
(Code)
2: PM Support Screen
[START]
(Operation started)
[POWER] OFF/ON
(Exit)
Warming up
Control panel
check mode
Test mode
Test print
mode
Adjustment
mode
Setting
mode
List print
mode
PM support
mode
Firmware
update mode
[POWER]
ON
Normal
Ready
[POWER]
OFF
To user
*1
[0][1] [0][3] [0][4] [0][5] [0][8] [9][START] [6][START] [8][9]
State transition diagram of self-diagnosis modes