6
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5520C/6520C/6530C
ERROR CODE and TROUBLESHOOTING
6 - 39
[E380]4th drawer transport jam (Paper not reaching the 4th drawer transport sensor)
1. Is the 4th drawer transport sensor working? (Perform the input check: 03-[COPY]ON/[5]/[E]).
* If it is working properly, proceed to 6. If not, check 2 to 5 below.
2. Check if the connector CN516 on the PFC board is disconnected from the 4th drawer transport
sensor or the harnesses are open circuited. Correct if so.
3. Check if the 4th drawer transport sensor is correctly installed or its detecting element is not
damaged or stained.
4. Replace the 4th drawer transport sensor.
5. Replace the PFC board.
6. Are the 4th drawer transport clutch and the 4th drawer feed clutch working? (Perform the output
check: 03-253, 03-251.)
* If they are working properly, proceed to 9. If not, check 7 to 8 below.
7. Check if the connector CN502 on the PFC board is disconnected from the 4th drawer transport
clutch or the 4th drawer feed clutch, or the harnesses are open circuited. Correct if so.
8. Replace the 4th drawer transport clutch or the 4th drawer feed clutch.
9. Is the feed/transport motor working? (Perform the output check: 03-122.)
* If they are working properly, proceed to 12. If not, check 10 to 11 below.
10.Replace the feed/transport motor.
11.Replace the PFC board.
12.Check if there is any abnormality on the driving section of the feed/transport motor or the roller.
Correct if any.
[E3F0]Tandem LCF transport jam (Paper not reaching the tandem LCF transport sensor)
1. Is the tandem LCF transport sensor working? (Perform the input check: 03-[SCAN]ON/[1]/[B].).
* If it is working properly, proceed to 6. If not, check 2 to 5 below.
2. Check if the connector CN505 on the PFC board is disconnected from the tandem LCF transport
sensor or the harnesses are open circuited. Correct if so.
3. Check if the tandem LCF transport sensor is correctly installed or its detecting element is not
damaged or stained.
4. Replace the tandem LCF transport sensor.
5. Replace the PFC board.
6. Are the tandem LCF transport clutch and the tandem LCF feed clutch working? (Perform the
output check: 03-252, 03-250.)
* If they are working properly, proceed to 9. If not, check 7 to 8 below.
7. Check if the connector CN502 on the PFC board is disconnected from the tandem LCF transport
clutch or the tandem LCF feed clutch, or the harnesses are open circuited. Correct if so.
8. Replace the tandem LCF transport clutch or the tandem LCF feed clutch.
9. Is the feed/transport motor working? (Perform the output check: 03-122.)
* If they are working properly, proceed to 12. If not, check 10 to 11 below.
10.Replace the feed/transport motor.
11.Replace the PFC board.
12.Check if there is any abnormality on the driving section of the feed/transport motor or the roller.
Correct if any.
To Next Page
Loading...
