e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
6 - 42
[E580]Stop jam at the bridge unit
1. Is the reverse sensor working? (Perform the input check: 03-[SCAN]ON/[3]/[E].))
* If it is working properly, proceed to 6. If not, check 2 to 5 below.
2. Check if the connector CN514 on the PFC board is disconnected from the reverse sensor or the
harnesses are open circuited. Correct if so (including CN538 and CN539 on the DRV board).
3. Check if the reverse sensor is correctly installed or its detecting element is not damaged or
stained.
4. Replace the reverse sensor.
5. Replace the PFC board.
6. Are the bridge unit transport exit motor and the reverse motor working? (Perform the output
check: 03-132-134, 03-136.)
* If they are working properly, proceed to 11. If not, check 7 to 10 below.
7. Check if the connector CN515 on the PFC board is disconnected from the bridge unit transport
exit motor or the reverse motor, or the harnesses are open circuited. Correct if so (including
CN537 and CN539 on the DRV board).
8. Replace the bridge unit transport exit motor or the reverse motor.
9. Replace the DRV board.
10.Replace the PFC board.
11.Check if there is any abnormality on the driving section of each motor or the roller. Correct if any.
[E2B0] Stop jam at the registration sensor (1st drawer)
[E2B1] Stop jam at the registration sensor (2nd drawer)
[E2B2] Stop jam at the registration sensor (3rd drawer)
[E2B3] Stop jam at the registration sensor (4th drawer)
[E2B4] Stop jam at the registration sensor (Bypass tray drawer)
[E2B5] Stop jam at the registration sensor (LCF)
[E2B6] Stop jam at the registration sensor (ADU)
[E2B7] Stop jam at the registration sensor (Option LCF)
1. Open the paper feed cover and check if there is any paper in front of the registration sensor.
Remove it if there is.
* If the error still occurs, check the following.
2. Is the registration sensor working? (Perform the input check: 03-[All OFF]/[4]/[B])
* If it is working properly, proceed to 5. If not, check 3 to 4 below.
3. Check if the connector CN516 on the PFC board is disconnected from the registration sensor or
the harnesses are open circuited. Correct if any.
4. Replace the registration sensor.
5. Is the registration motor rotating? (Perform the input check. 03-128/528)
6. Check if the connector CN512 on the PFC board is disconnected from the registration motor or
the harnesses are open circuited. Correct if any.
7. Replace the registration motor.
8. Replace the PFC board.
9. Check the rollers. Replace them if they are worn out.
To Next Page
Loading...
