Toshiba e-STUDIO6520c - Page 44

e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
2 - 6
[6]
A K-ATS connection detection Not connected Connected
B C-ATS connection detection Not connected Connected
C M-ATS connection detection Not connected Connected
D Y-ATS connection detection Not connected Connected
E- --
F- --
G- --
H- --
[7]
A Pressure roller sub heater lamp wattage
detection
800 W 200 W
B- --
C- --
D Shutter motor end position detection /
Shutter sensor (end position)
(Refer to table 1)
OFF (H) ON (L)
E Shutter motor home position detection /
Shutter sensor (home position)
(Refer to table 1)
OFF (H) ON (L)
F- --
G- --
H Pressure roller temperature abnormality Normal Excessively high
[8]
A IH error signal-2
(Refer to table 2)
OFF (H) ON (L)
B IH error signal-1
(Refer to table 2)
OFF (H) ON (L)
C IH error signal-0
(Refer to table 2)
OFF (H) ON (L)
D- --
E- --
F- --
G Image position aligning sensor (rear) Detecting reflection
light from the belt
Not detecting
reflection light from
the belt
H Image position aligning sensor (front) Detecting reflection
light from the belt
Not detecting
reflection light from
the belt
[9]
A Color drum phase sensor Sensor shielded Sensor not shielded
B K drum phase sensor Sensor shielded Sensor not shielded
C Transfer belt paper clinging detection sensor Paper present No paper
D 2nd transfer side paper clinging detection
sensor
Paper present No paper
E- --
F- --
G Image position aligning sensor (Center) Detecting reflection
light from the belt
Not detecting
reflection light from
the belt
H 2nd transfer roller contact / release detection
sensor
Released
(home position)
Contacted
Digital
key
Button Items to check
Contents
Highlighted display
e.g.
Normal display
e.g.