e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
6 - 60
[EA70] Stack exit belt home position error
1. Check if the connector CN11 on the finisher controller PC board is disconnected from the stack
belt exit home position sensor (S9) and the harnesses are open circuited. Correct if any.
2. Is the harness between the stack transport motor (M5) and the finisher control PC board (CN10)
disconnected or open circuited?
3. Replace the sensor.
4. Replace the finisher controller PC board.
5. Is the upper surface detection sensor normal? (See CB31.)
To Next Page
Loading...
