Toshiba e-STUDIO6520c - Page 452

e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
6 - 70
[EF19] Saddle Stitch Finisher paper folding jam
Is there any paper remaining in the paper transport path in the equipment or the saddle stitch
section of the Finisher?
È
ÆYES Remove the paper.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the exit transport
sensor (S41)?
l
l
È
ÆYES • Reconnect the connector securely if there is any disconnection.
• Reinstall the sensor correctly if there is any incorrect installation.
• Replace the sensor if there is any breakage.
NO
Is the harness between the exit transport sensor (S41) and the CN19 of the saddle control PC
board (SDL) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely if there is any disconnection.
• Replace the harness if open circuited.
NO
Replace the saddle control PC board (SDL).
[EF20] Saddle stacker jam
Is there any paper remaining in the paper transport path in the equipment or the saddle stitch
section of the Finisher?
È
ÆYES Remove the paper.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the stacker paper
detection sensor (S30)?
l
l
È
ÆYES • Reconnect the connector securely if there is any disconnection.
• Reinstall the sensor correctly if there is any incorrect installation.
• Replace the sensor if there is any breakage.
NO
Is the harness between the stacker paper detection sensor (S30) and the CN14 of the saddle
control PC board (SDL) disconnected or open circuited?
l
È
ÆYES • Reconnect the connector securely if there is any disconnection.
• Replace the harness if open circuited.
NO
Replace the saddle control PC board (SDL).