e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
REPLACEMENT OF PC BOARDS/HDD
7 - 32
[I] Set EFI Printer Board
If the EFI Printer Board (GA-1310) is installed, perform the following procedure.
(1) Turn the power OFF.
(2) Start the setting mode (08).
(3) Initialize the EFI Printer Board (08-700).
(4) Turn the power OFF.
[J] Reinstall options
When any of the options below was installed, reinstall a license for the corresponding option following
its unpacking instructions.
• Meta Scan Enabler (GS-1010)
• External Interface Enabler (GS-1020)
• IPSec Enabler (GP-1080)
When GP-1070 (Data Overwrite Enabler) has been installed, “F200” service call occurs. In this case,
perform cancelling the “F200” service call (installing the OS / HDD SYS / PFC Firmware / Engine
MainFirmware / Scanner Firmware using the USB media), and then install GP-1070 (Data Overwrite
Enabler) again.
To Next Page
Loading...
