e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
2 - 18
224 Sub-hopper toner motor-Y (reverse rotation) ON/OFF
(The toner will not be supplied but only mixed within the Y sub-hopper)
3
(*4)
225 Sub-hopper toner motor-M (reverse rotation) ON/OFF
(The toner will not be supplied but only mixed within the M sub-hopper)
3
(*4)
226 Sub-hopper toner motor-C (reverse rotation) ON/OFF
(The toner will not be supplied but only mixed within the C sub-hopper)
3
(*4)
227 Sub-hopper toner motor-K (reverse rotation) ON/OFF
(The toner will not be supplied but only mixed within the K sub-hopper)
3
(*4)
234 Waste toner transport motor ON/OFF 3
237 Transfer belt cam motor ON/OFF
(Operation stops after the belt is released)
2
239 TRU waste toner motor (normal rotation) ON/OFF
(DC motor driving the auger for transporting waste toner from the 2nd transfer unit)
3
240 TRU waste toner transport motor ON/OFF
(DC motor driving the auger for transporting waste toner to a TRU waste toner box)
3
241 2nd transfer unit waste toner exit mode ON/OFF
(A mode used for transporting waste toner accumulated in the 2nd transfer unit to a TRU
waste toner box)* Perform the codes 03-239 and 03-240 simultaneously.
3
243 2nd transfer roller contact/release
(2nd transfer motor ON/OFF & 2nd transfer roller contact/release clutch ON/OFF)
3
244 2nd transfer roller drive clutch ON/OFF 3
246 Tray-up motor-1(1st drawer) ON (Tray up) 2
247 Tray-up motor-1(2nd drawer) ON (Tray up) 2
248 Tray-up motor-2(3rd drawer) ON (Tray up) 2
249 Tray-up motor-2(4th drawer) ON (Tray up) 2
250 3rd drawer feed clutch or tandem LCF feed clutch ON/OFF
(Each clutch turns ON or OFF according to the installation status of the corresponding
drawer.)
3
251 4th drawer feed clutch ON/OFF 3
252 3rd drawer transport clutch or tandem LCF transport clutch ON/OFF
(Each clutch turns ON or OFF according to the installation status of the corresponding
drawer.)
3
253 4th drawer transport clutch ON/OFF 3
254 Bypass pickup solenoid ON/OFF 3
255 Tandem LCF solenoid ON/OFF 3
256 Tandem LCF end fence motor reciprocating movement 2
257 Tandem LCF tray-up motor (Tray up/down) 2
258 Tandem LCF stopper opening/closing solenoid (front) ON/OFF 3
259 Tandem LCF stopper opening/closing solenoid (rear) ON/OFF 3
261 Scan motor ON (Automatically stops at limit position) 2
264 Scanner fan motor (high speed) ON/OFF 3
265 Scanner fan motor (low speed) ON/OFF 3
267 Scanner exposure lamp ON/OFF 3
268 Option LCF feed clutch ON/OFF 3
269 Option LCF transport clutch ON/OFF 3
270 Option LCF tray-up motor (Tray up/down) 2
272 Pressure roller contact/release
(Fuser motor (reverse rotation) ON & Pressure roller contact/release clutch ON, operation
stops after the roller is released)
2
273 Pressure roller contact/release clutch ON/OFF 3
Code Function Procedure
To Next Page
Loading...
